Nuclear radiation environment analysis for thermoelectric outer planet spacecraft

Neutron and gamma ray transport calculations were performed using Monte Carlo methods and a three-dimensional geometric model of the spacecraft. The results are compared with similar calculations performed for an earlier design

They (Don't) Care About Education: A Counternarrative on Black Male Students' Responses to Inequitable Schooling

Focus group interviews and systematic content analysis of 304 essays written by black male undergraduates refute the dominant message that black men do not care about education. On the contrary, these students aspire to earn doctoral degrees in education despite acute understanding that the education system is stacked against them. The analysis asks what compels that dedication

Pollution reduction technology program for small jet aircraft engines: Class T1

Small jet aircraft engines (EPA class T1, turbojet and turbofan engines of less than 35.6 kN thrust) were evaluated with the objective of attaining emissions reduction consistent with performance constraints. Configurations employing the technological advances were screened and developed through full scale rig testing. The most promising approaches in full-scale engine testing were evaluated

Ring baffle pressure distribution and slosh damping in large cylindrical tanks

An investigation was conducted to determine the pressure loads and damping associated with rigid ring baffles in relatively large cylindrical tanks. The radial and circumferential pressure distribution, as well as the damping, was measured on a ring baffle subjected to fundamental antisymmetric slosh in a 284-cm-diameter rigid tank. Experimental and analytical data are presented as a function of slosh velocity or amplitude, baffle spacing, and baffle locations both above and below the liquid surface. Results suggest that pressure distributions and damping values can be determined from available theories for the design of single and multiple baffle configurations

Rotorcraft contingency power study

Twin helicopter engines are often sized by the power requirement of a safe mission completion after the failure of one of the two engines. This study was undertaken for NASA Lewis by General Electric Co. to evaluate the merits of special design features to provide a 2-1/2 Contingency Power rating, permitting an engine size reduction. The merits of water injection, turbine cooling airflow modulation, throttle push, and a propellant auxiliary power plant were evaluated using military Life Cycle Cost (LCC) and commercial helicopter Direct Operating Cost (DOC) merit factors in a rubber engine and a rubber aircraft scenario

ERBS fuel addendum: Pollution reduction technology program small jet aircraft engines, phase 3

A Model TFE731-2 engine with a low emission, variable geometry combustion system was tested to compare the effects of operating the engine on Commercial Jet-A aviation turbine fuel and experimental referee broad specification (ERBS) fuels. Low power emission levels were essentially identical while the high power NOx emission indexes were approximately 15% lower with the EBRS fuel. The exhaust smoke number was approximately 50% higher with ERBS at the takeoff thrust setting; however, both values were still below the EPA limit of 40 for the Model TFE731 engine. Primary zone liner wall temperature ran an average of 25 K higher with ERBS fuel than with Jet-A. The possible adoption of broadened proprties fuels for gas turbine applications is suggested